Assessment of factors limiting technological capabilities crimping conical die blanks from thick-walled pipes

Authors

  • Валерий Александрович Коновалов Omsk State Technical University, Omsk, Russia
  • Юлия Анатольевна Чугунова Omsk State Technical University, Omsk, Russia

DOI:

https://doi.org/10.25206/1813-8225-2019-165-11-15

Keywords:

crimping, conical matrix, thick-walled pipe, inlet, technological capabilities

Abstract

The results of an experimental study of the formation of thickwalled hollow products compressed with conical matrices are
presented. The influence of the characteristics of the tool and the size of the blanks on the technological capabilities of crimping is established. The quantitative evaluation is made in the form of graphs, which make it possible to predict more accurately the final configuration and dimensions of the stamped product.

Downloads

Download data is not yet available.

Author Biographies

Валерий Александрович Коновалов, Omsk State Technical University, Omsk, Russia

кандидат технических наук, доцент кафедры «Машиностроение и материаловедение».

Юлия Анатольевна Чугунова, Omsk State Technical University, Omsk, Russia

студентка гр. М-152 машиностроительного института.

Downloads


Abstract views: 3

Published

2019-06-10

How to Cite

[1]
Коновалов, В.А. and Чугунова, Ю.А. 2019. Assessment of factors limiting technological capabilities crimping conical die blanks from thick-walled pipes. Omsk Scientific Bulletin. 3(165) (Jun. 2019), 11–15. DOI:https://doi.org/10.25206/1813-8225-2019-165-11-15.

Issue

No. 3(165) (2019)

Section

Mechanical Engineering and Engineering Science

License

Non-exclusive rights to the article are transferred to the journal in full accordance with the Creative Commons License BY-NC-SA 4.0 «Attribution-NonCommercial-ShareAlike 4.0 Worldwide License (CC BY-NC-SA 4.0»)

by-nc-sa

Similar Articles

You may also start an advanced similarity search for this article.