Determination of the optimal mode of FDM printing with composites to obtain the required design and technological parameters

Authors

  • Markanov Ilya Denisovich Samara National Research University, Russia, Samara
  • Vdovin Roman Alexandrovich Samara National Research University, Russia, Samara
  • Goncharov Evgeny Stanislavovich Samara National Research University, Russia, Samara
  • Firsin Andrey Olegovich Samara National Research University, Russia, Samara

DOI:

https://doi.org/10.25206/2588-0373-2024-8-1-78-85

Keywords:

3D printing, additive manufacturing, additive technologies, FDM printing, 3D printer, composite materials, printing mode, plastic

Abstract

This paper discusses properties of various 3D printing materials, namely, plastics, including polyamides, along with composite or engineering plastics with inclusions of carbon fiber and fiberglass. We have selected an optimal sample printing mode and carried out experiments, following which we have determined maximal loads for test composite materials, and linear shrinkage. As the result, we have determined an optimal 3D printing mode for various structures of composite material parts with the purpose to reach the set design–engineering parameters.

Downloads

Download data is not yet available.

Author Biographies

Markanov Ilya Denisovich, Samara National Research University, Russia, Samara

Laboratory Researcher of Engineering Centre EC-206, Samara National Research University (Samara University), Samara.

Vdovin Roman Alexandrovich, Samara National Research University, Russia, Samara

Candidate of Technical Sciences, Associate Professor, Associate Professor of Engine Manufacturing Technologies Department, Associate Professor of Advanced Aerospace Engineering School, Samara University, Samara.

Goncharov Evgeny Stanislavovich, Samara National Research University, Russia, Samara

Engineer of Engine Manufacturing Technologies Department, Engineer of Engineering Centre EC-206, Assistant of Advanced Aerospace Engineering School, Samara University, Samara.

Firsin Andrey Olegovich, Samara National Research University, Russia, Samara

Laboratory Researcher of Engineering Centre EC-206, Samara University, Samara.

Downloads


Abstract views: 43

Published

2024-03-29

How to Cite

Markanov И. Д., Vdovin Р. А., Goncharov Е. С., & Firsin А. О. (2024). Determination of the optimal mode of FDM printing with composites to obtain the required design and technological parameters. Omsk Scientific Bulletin. Series «Aviation-Rocket and Power Engineering», 8(1), 78–85. https://doi.org/10.25206/2588-0373-2024-8-1-78-85

Issue

Vol. 8 No. 1 (2024)

Section

Aviation and rocket-space engineering

License

Non-exclusive rights to the article are transferred to the journal in full accordance with the Creative Commons License BY-NC-SA 4.0 «Attribution-NonCommercial-ShareAlike 4.0 Worldwide License (CC BY-NC-SA 4.0»)

Creative Commons License