Submissions

Author Guidelines

Guide line for Submission and Publishing of Articles

About the content. The article should contain only original material reflecting the results of the author's research not previously published
and not submitted to other publications.

On the review of the submitted materials. At the first stage all scientific articles undergo mandatory testing for borrowings. Articles containing
less than 70 % of the unique text and violating publishing requirements are returned to the author (authors). Articles that have passed
the verification of the uniqueness of the text and following the journal profile are sent for reviewing. The comments are transmitted
to the author (authors). After the finalization, the reviewers analyze the materials again, after which the decision for publication is made.

Article format. The article should be typed in a text editor Word (with the extension *.doc or *.docx) (font — Times New Roman Cyr 14 pt,
indentation — 0,5 cm, line spacing — one and a half without hyphenation in words). Print on paper in A4 format (210×297 mm). Pages should be
numbered with a pencil on the back. The volume of the article is 16–18 pages, including figures and tables (excluding annotations, keywords,
bibliographic list and information about authors); the text of the article should be at least 8–10 pages.

Margins: from above and from below — on 2,5 cm; left and right — 2 cm.

Header. In the upper left corner of the sheet the UDC is placed. Further, in the center, the title of the article is printed (the capital letter is only the first).
The title of the article can not be abbreviated. Below there are initials, the author's (authors') surname, the line below — the full name of the organization,
through the comma — country, city, street name, house number, postcode.

Below the line the text of the annotation and keywords in Russian are placed.

The abstract should reflect the main topic of the article, its relevance, purpose and objectives, as well as its results. In the annotation, the author (authors)
indicates that the work is new in comparison with others related to the topic and purpose. The recommended average annotation volume is over 500 characters.

Keywords — 6–8 words/phrases, which should reflect the specifics of the topic, the subject and the results of the research. It is necessary to avoid common
words and phrases. When selecting keywords, it is recommended to use terms and phrases used in the areas researched.

Next, the main text of the article is placed through the line.

The text of the article should be structured and contain the following sections: «Introduction», «Statement of the problem», «Theory», «Experimental results»,
«Discussion of experiments»,«Conclusions».

If there are notes in the text, after the main text, before the Source list, the title «Notes» is typed in the center and the text of the notes, numbered
in the form of an upper index (for example, ¹) in the order of the references in the text, is placed through the line. The reference to the note in the main
text is bolded with a number in the form of an upper index (for example, ...models¹). Automatic numbering of the notes is not allowed.

The «Introduction» section includes the relevance of the research topic, a review of the literature on the research topic (the initial hypotheses, if they exist),
the object of the study, the statement of the problem.

The Statement of the problem should follow from the results of the literature review and contain the formulated goal and a list of tasks to be solved.

The section «Theory» contains theoretical analysis and theoretical studies.

The sections «Results of experiments» and «Discussion of results» contain the actual results of the research (text, tables, graphs, diagrams, equations,
figures)and interpretation of the results of the research, respectively.

The section «Conclusions» contains brief summaries of the sections of the article without repeating the formulations given in them.

Formulas. Simple inline and single-line formulas that do not contain special characters (absent on the keyboard) must be typed with symbols from
the keyboard without using special editors. Single special characters that are not present on the keyboard, formulas containing special characters that
are not on the keyboard, and complex and multi-line formulas must be typed entirely in the Microsoft Equation 3.0 or MathType formula editor. It is not allowed
to type part of the formula with symbols, and parts in the formula editor. If in the text of the article the formulas are numbered, then this numbering
should be performed by a set of numbers. Automatic numbering is not allowed.

List of sources. Below the main text, the title «List of sources» is printed down the line and a numbered source list is placed through the line in the order
of the text references in accordance with the current editorial requirements for the bibliographic description. Only one source of information should be
indicated in one item of the list.

The text of the article should contain references to information sources (at least 15–20 sources):

— obligatory citation of modern works (the share of quoted publications published on the subject of the article is estimated over the past 5 years);
— the existence of a balance between references to domestic and foreign publications (shows how much the author (authors) of the manuscript know
the current state of the problem in Russia and abroad);
— the share of links to the articles of the author (authors) published earlier should not exceed 20 % of the total number of references.

References to information sources are numbered sequentially, as far as they are mentioned in the text, and are denoted by numbers enclosed in square
brackets (for example, [1]). If the reference to the source of information in the article is mentioned repeatedly, then its number from the list is repeated
in square brackets (without using the next sequence number and the link «Ibid» in the Source list). In the case when they refer to different materials from
the same source, the page number is also indicated in square brackets each time, for example, [1, p. 17] or [1, p. 28–29].

Tables are placed on a new page after the Source list. The numbering of tables is made in the order of the references in the text. The numbering header
of the table is typed in a font with boldface, aligned to the left.

Table names are given simultaneously in Russian and English:

Table 1. Name in Russian
Table 1. Title of the table in English

The reference to the table in the main text is drawn in a font with boldface in parentheses — for example, (Table 1).

No more than 8–10 tables are allowed.

The figures should be placed after the paragraph they have been referred to for the first time. The numbering of figures is made in the order of the references
in the text. The numbering header is typed in a font with boldface, aligned to the center of the picture.

The names of the figure are given simultaneously in Russian and English:

Fig. 1. Name in Russian
Fig. 1. Title of the figure in Russian

The reference to the figure in the main text is made in a font with boldface and in parentheses — for example, (Fig. 1). Figures can be scanned from the original
(with a resolution of 150–300 dpi) or executed by means of computer graphics and saved in the formats JPEG, TIFF, BMP, PSD. The file size of the figure should
not exceed 3 MB. The use of graphics in MS Visio format, various CAD and other programs is not allowed. Figures should be clear. All positions in the figure
must be decoded and described. The legend of the figure should be easy to read, the font is not less than 8–9 pt. It is allowed, and in the case of illustrations
of a large volume (file), the placement of pictures in a separate electronic version file is welcome. The name of the figure is placed directly under the figure
and should not be included in the format of the figure.

No more than 8–10 figures are allowed.

On the last page indicate the following information about the author (authors): surname, name, patronymic; academic degree, academic title, position,
place of work, telephone number (not published); address for correspondence; for nonresident authors – the postal address to which the journal is sent
in case of publication of their article; SPIN-code, AuthorID (RSCI), ORCID, AuthorID (SCOPUS), ResearcherID.

A separate page contains the English-language part of the article.

In the upper left corner of the sheet in English, the UDC is affixed. Further, in the center, the title of the article is printed (the capital letter is only the first) in English.

Below in English — initials, author (authors) surname, the line below — the full name of the organization, followed by a comma — country, city, street name, house number, postcode.

The line below is an Abstract and Keywords.

The Abstract should be informative, reflect the main content of the article and the results of the research. The volume is 150–250 words. It should not be a literal translation
of the Russian version.

Keywords are placed under the annotation — 6–8 words/phrases, which should reflect the specifics of the topic, the subject and the results of the research. It is necessary
to avoid common words and phrases. When selecting keywords, it is recommended to use terms and phrases used in the areas researched.

The line below is, if any, Acknowledgments.

The line below is the List of Sources in Latin, called References.

Description of References:

1. Authors (Surname, Name, Second Name) — transliteration.
2. The title of the article is transliteration.
3. The title of the article in English in square brackets.
4. The title of the publication is transliteration.
5. Name of the publication in English.
6. Imprint: place of publication, year, number, pages — in English.
7. At the end of the link in parentheses, indicate the source language in English, for example, (In Russ.).

For transliteration use the standard BGN (United States Board on Geographic Names).
 

It is necessary to submit a printed version of the article (with a personal signature of the author (authors)) and an electronic version of the article 
(send by e-mail: onv@omgtu.ru), the original expert conclusion on the possibility of open publication and author agreement.
Address: 644050, Omsk, Mira Ave., 11, Building 6, Office 424, OmSTU, the Editorial Board of the journal Omsk Scientific Bulletin. 
Tel. +7(3812) 65-32-08, e-mail: onv@omgtu.ru
The system of online reception of the articles is available: http://onv.omgtu.ru/article.php